Bedini 3 Pole Kit Notes - Eagle-Research（笔记Eagle-Research Bedini 3杆工具包）.pdfVIP

Bedini 3 Pole Kit Notes From George Wiseman of Eagle-R: NOTE : I helpe d assemble a kit at the Sympos ium, but, as of today (November 24/10) have not y et received my kit. I was thef irst one NOT to receive a kit at the Sympos ium. They pl annedf or 250 and accept ed about 380 pe ople. Notes about assembly of Classic 3 Coil Bedini Monopole Generator/Motor Kit at Coeur d’Alene Symposium on November 13/10 /2010/ 11/23/9501730_Bedini_Renaissance_Conference_a_turning_point/ Sitting at table ~ John Mcginnis, ? Gustafson, Lee ? (owner of kit), North Dakota Indian (fiber optic installer). Sorry Guys, I didn’t get your names properly. We WERE one of the first to get our motor running… Whooo Hoooo  Note: this was not our motor, we weren’t allowed to take pi ctures. I got this off the web. Tips learned as assembly happened at our table: Notes that were not included in the instructions given to us. They may have been on the disk. 1. Mount magnets with North pole facing out. North pol e will poi nt North if spun on a sheet of pape r; will also attract the south po le of a compas s. 2. Shim rotor magnets with something (John Bedini said paper). The magnets need to be secure to the outer rim of the rotor. Movement robs power from the rotor. Maybe that ’s what the glue wasf or. 3. Make sure the o-rings are on the shaft BEFORE you snap together the rotor. You can take the rotor apart by releasing the snap clips a pai r at a time (guess why we needed to know that?). 4. Put drive coil position adjuster on the base before installing the rotor stands. 5. Pack core rods tightly and tap them in with a hammer. You want just enough rods so that they stay in the core (too many will split the core). It helps to put them in and push them all down at once. We had some spar es in our kit. Classic 3 Pole Kit Bedini Motor Circuit, redrawn by George Wiseman Eagle-R