ASSEMBLY INSTRUCTIONS 2” EXTRUDED （汇编指令2u201D挤压）.pdfVIP

ASSEMBLY INSTRUCTIONS 2” EXTRUDED PORCH ENCLOSURE SYSTEM screenhousesunlimited do-it-yourself home improvement kits 1.800.922.4760 March, 2008 Page 1 STEP 1: INSTALL MOUNTING CHANNELS (Figure 1) NOTE: When quoting a screen enclosure, we do our best to make the smartest use of materials in order to keep the pricing as reasonable as possible. Sometimes, the most efficient use of materials (due to the materials only being available in certain standard lengths) will mean the end user will be required to butt splice certain screen enclosure profiles. Butt splicing will be the most common for top, bottom, and rear wall u-channels but can also sometimes include vertic al framing members as long as they are in a u- channel. Install H123 (1 X 2 C channel) and H124 (2 X 2)to the floor and vertical starting walls. Install H124 (2 X 2 C channel) to the underside of the roof line of the area to be enclosed. It is suggested that H123 (1 X 2) channel be used on the floor and walls and the H124 (2 deep) channel be used on the overhead area to be enclosed to accommodate extreme unlevel or out of plumb conditions. If you are mounting the floor channel to concrete, it is suggested that you use a hammer drill and the (optional) A421A drive anchors to secure the U-channel to the concrete. In addition, use some outdoor/industrial grade waterproofing sealant either between the concrete and U-channel, or on the outside edge of the U-channel against the concrete to prevent water from seeping under the channel and into the room when it rains. Channel mounted to wall should be sealed against wall by means of ¾ X ¾ foam tape (H310A) in the case of step type siding. Due to the many different types and styles of housing walls, you will need to supply your own screws/fasteners t