Factory Acceptance Testing Guideline - SP（工厂验收测试指南- SP）.pdf

下载文档 降价啦

106
0
约2.08万字
约 16页
2017-07-29 发布于浙江
举报
版权申诉
保障服务

Factory Acceptance Testing Guideline - SP（工厂验收测试指南- SP）.pdf

1、本文档共16页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

Factory Acceptance Testing Guideline - SP（工厂验收测试指南- SP）

Factory Acceptance Testing Process Industry Guideline IEC 61511 Version: 1.0 Last Edited:2006-08-25 Factory Acceptance Testing Guideline Comments on this report are gratefully received by Johan Hedberg at SP Swedish National Testing and Research Institute mailto:johan.hedberg@sp.se www.sp.se/safeprod -1- Factory Acceptance Testing Process Industry Guideline IEC 61511 Version: 1.0 Last Edited:2006-08-25 Summary According to the standard IEC 61551 the factory acceptance test (FAT) is not a requirement but is necessary to carry out if the application software of the logic solver is complex or if the architecture is using redundant arrangements. The general questions in the planning phase of the FAT concern the tests to be performed and how to deal with the tests. The FAT is a practical way to test and verify the correct operation of the safety instrumented system. www.sp.se/safeprod -2- Factory Acceptance Testing Process Industry Guideline IEC 61511 Version: 1.0 Last Edited:2006-08-25 Table of contents 1. Introduction 4 1.1.