离合器的使用（Clutch use）.docVIP

离合器的使用（Clutch use） The clutch uses.Txt the heart is a two bedroom house, one living in pain, one living happily. People cant laugh too loudly, or they will wake up the pain next door. Clutch use Stationary start: Neutral, press the clutch, step in the end, hang a gear, slowly release the clutch, cooperate with the throttle, the car go. If you dont have a good command of half clutch stroke, stupid way is left with always on the floor, on the left foot with the axis, slowly lift left foot force control, at the same time feel wobbly and mobile trend of the vehicle when the vehicle has a slight jitter and the emergence of mobile trend is the so-called semi linkage region, then slowly filling. Continue to slowly release the clutch, until the complete release of the vehicle start smoothly. This method cannot be used for a long time, the right way is to lift the knee force, such as skilled remember half linkage stroke position, further requirements, half linkage before up fast, half linkage during slow, oil is slow to fast, 2 seconds to complete the start even if there is a small. Gear shift in motion: When the vehicle is shifting gears, the oil separation is more important, and the improper operation will cause serious damage to the gear box. As the speed increases, the process of oil separation will gradually shorten, that is, the speed of the clutch pedal will be released faster. In order to ensure smooth throttle, to cooperate with the early, grinding car late in frustration, about half clutch to light oil, oil to the clutch, this time is very short, to get used to hold. In the higher gear upshift, namely speed faster, the manipulation of the clutch pedal down and should be quickly lifted, half linkage or eliminate as far as possible to shorten the time, otherwise it will accelerate clutch wear, but also reasonable with the throttle. The ideal condition is that during the shift, the vehicle runs smoothly, the speed increases slowly, and there is no obvious instantaneou