漆膜划格器（Paint film scriber）.docVIP

漆膜划格器（Paint film scriber） GP- 502 paint booth instructions 1 Introduction The principle of the instrument to Cartesian grid graphics cutting coating substrate to evaluate the resistance to penetration from the coating from the substrate, can also be used for multi-layer coating system to evaluate the coating system in the coating from each other from the coating resistance. 2 ordering information and packing GP- 502 contains a plastic carrying case Lattice / handle 3M test tape 1 volumes, wolf Hao brush 1 3 times 1 magnifying glasses The GP-502/2 contains a six blade cutting surface of the cutter head (1mm/100 lattice) and 1 3 4 5 6 The GP-502/3 contains a six blade cutting surface of the cutter head (1mm/25 lattice) and 1 3 4 5 6 The GP-502/4 contains a six blade cutting surface of the cutter head (2mm/100 lattice) and 1 3 4 5 6 The GP-502/5 contains a six blade cutting surface of the cutter head (2mm/25 lattice) and 1 3 4 5 6 The GP-502/6 contains a six blade cutting surface of the cutter head (3mm/25 lattice) and the 4 5 6 and 1. 3 instructions The design of the film maker conforms to standard ASTM, D3359, BS, 3900E6, BS/EN, ISO 2409 and GB/T 6739. In order to obtain accurate data during the experiment, users must strictly follow these standards. 4 operation steps The following steps can provide the correct method for the user, of course, these steps are in strict accordance with the standard requirements, the resulting data is meaningful and can be used to evaluate the hardness of the coating. 4.1 select the correct cutter head 1mm spacing - 25 squares: used for hard substrates (such as metals) with a coating thickness of less than 60 mu m and capable of cutting out 25 small squares. 1mm spacing - 100 squares: used for hard substrates (such as metals) with a coating thickness of less than 60 m, also known as a hundred cell knife, can be cut out of 100 small squares to facilitate rapid assessment of coating detachment percentage. 2mm spacing: used for hard substr