液晶屏维修（LCD maintenance）.docVIP

液晶屏维修（LCD maintenance） LCD TV is also called the pressure plate or the backlight inverter power supply, its effect is the low voltage DC power output voltage change of high-frequency high-voltage alternating current required for the liquid crystal panel, CCFL backlight LCD panel light. In the LCD TV in the circuit made of a strip of general independent circuit board, because this part of the circuit components using double-sided installation, compact layout, and the output AC voltage from 1 500V to 1 800V, so the failure rate is high. Therefore, for the maintenance of the high voltage board, both the method of replacing a single fault component can be adopted, or the method of replacing the whole plate can be adopted, that is to say, the plate type maintenance. First, the high-voltage circuit fault judgment, for high-voltage inverter circuit overhaul, the following methods can be used for analysis and judgment. Touch 1. pressure test bar, the boot flash black screen failure, can be as follows: immediately after boot, with pressure bar test (also available multimeter) touch the high-voltage output plug feet, to see whether there is a faint blue spark, if a spark occurs, the fault in the lamp tube is not bright or connector. Watch out for multiple tubes, and test them one by one. This emphasis on testing immediately after the boot, mainly in order to avoid the protection of the circuit after the start of miscarriage of justice. According to the actual experience, even when the cooler tube is damaged, the protection circuit start also takes a few seconds, and the engine or just disconnect the power and soon re energized, the protection circuit to start only 1s ~ 2S, so to grasp the detection time. The fault phenomenon after the main components of the Royer inverter circuit is damaged is shown in figure 1. If the protection circuit does not work without the measured discharge spark is generated, it should be measured at all levels of supply voltage is normal, the backli