受压构件配筋构造要求.pdfVIP

8.8 Detailing requirements for reinforcement: ◆ The diameter of the longitudinal rods should not be smaller ◆ than 12mm，and the larger diameter rods are recommended, and the number of rods in the member should not be less than 4，in circular sections, should not be less than 8. ◆ The requirement of the cover of the concrete is in table 8-3， ◆ and no less than d。 8.8 受压构件的配筋构造要求 ◆ The clear spacing of longitudinal bars should not be less than ◆ 50mm； ◆When the prefabricated column is cast horizontally, the ◆ smallest diameter should follow the code. ◆ Spacing between longitudinal bars measured along the ◆ periphery should not exceed 350mm.When h ≥600mm， additional longitudinal rods with a diameter of 10~16mm should be placed on the lateral sides. 8.8 受压构件的配筋构造要求 配筋构造： ◆ 柱中纵向受力钢筋的的直径d不宜小于12mm，且选配钢筋时 ◆ 宜根数少而粗，但对矩形截面根数不得少于4根，圆形截面根 数不宜少于8根，且应沿周边均匀布置。 ◆ 纵向钢筋的保护层厚度要求见表8-3，且不小于钢筋直径d 。 ◆ ◆ 当柱为竖向浇筑混凝土时，纵筋的净距不小于50mm； ◆ ◆ 对水平浇筑的预制柱，其纵向钢筋的最小应按梁的规定取 ◆ 值。 ◆ 截面各边纵筋的中距不应大于350mm 。当h ≥600mm时，在 ◆ 柱侧面应设置直径10~16mm的纵向构造钢筋，并相应设置复 合箍筋或拉筋。 8.8 受压构件的配筋构造要求 8.8 受压构件的配筋构造要求 Lateral ties ： ◆ The diameter of the ties should not be less than d/4 of the ◆ diameter of the largest longitudinal rods ，and in no case be less than 6mm ，and the ties in the compressive member should be closed. ◆ The spacing should not be greater than the shorter side of the section or 400mm ；In a tied and welded skeleton member, the spacing of the ties along the length of the member should not be greater than 15d and 20d respectively. Here d is the diameter of the smallest longitudinal rods 。