数控电火花成型加工机床操作视频教程-零件加工实例（CNC EDM machine tool operation video tutorial - parts processing examples）.docVIP

数控电火花成型加工机床操作视频教程-零件加工实例（CNC EDM machine tool operation video tutorial - parts processing examples） I. processing requirements The parts are made of steel and require a 10 * 10 * 2 cavity in the center of the rough surface. Processing equipment: CJ-340 CNC EDM machine tools Two. Preparation Complete the preparation before processing, including process analysis and process route design, electrode selection, machining process parameter selection, programming and so on. Three, operation steps and content 1, turn on the machine, each axis returns to zero The red emergency stop button to undo, click the green ON button, and then click the RESET button to reset; click F1 (corresponding to zero, and then click the machine (F1) Corresponding to three axis return to zero). 2 、 parts clamping and aligning Place one side of the workpiece close to the positioning side of the magnetic chuck, and then turn on the switch of the magnetic chuck (OFF = ON) ). (if the magnetic disc doesnt look right, you need to look for it right.) 3 、 electrode clamping alignment According to the processing requirements, choose a 3 thin copper wire as the tool electrode, put the electrode on the main shaft head, after the alignment, clamping. The specific steps are: to find the electrode is arranged on the spindle, the dial indicator on the work table, the dial indicator stylus pressure on the electrode, and then use the moving spindle box manually, see to adjust the electrode position indicator. 4. Set the origin of the programming coordinate system Click F2 (corresponding to manual mode), open the manual box switch, through the manual box of X+, X-, Y+, Y-, Z+, Z- Moving table and main shaft head. The mobile electrode to workpiece left to bottom surface of the upper surface of the workpiece is higher than that of the electrode, and then click F6 (corresponding heartseeker edge), then click F1 (corresponding to the profiling X+) after lifting the spindle, and use this method by X-. Then, start with