消防保养（Fire maintenance）.docVIP

消防保养（Fire maintenance） Precautions in maintenance inspection The purpose of maintenance inspection is to check out the problems existing in the fire protection system, but we must avoid any damage or misjudgment due to our negligence and ignorance. The first response to the entire fire control system to have a general understanding, especially the linkage system, do not know the equipment do not start before the start, notify the person to guard, because otherwise we start the pump, air conditioning, elevator, strong power cut, there may also be some other equipment, may cause damage to their work, passive. During automatic testing, isolate the equipment that does not want to start automatically. Here are some considerations for system checking. I. automatic alarm system This system is generally familiar to people, and will not cause serious accidents, but some places should also pay attention to: 1 、 the field equipment such as the test detector is not calibrated or positioned incorrectly on the drawings, and some Chinese characters are incorrect or incomplete. 2, the controller should first clean shutdown, and then use the fine brush gently sweep dust. Where the plate must be removed, remember to assemble and disassemble the position. 3, pay attention to the controller linkage formula and the black box record is normal. Two fire hydrant system and water spraying system This system is generally less contact with people, if not properly handled, there will be serious consequences. Points for attention are as follows: 1, fire hydrant system general bottom static pressure not more than 8kg, dynamic pressure 5kg. 2, at the most unfavorable pressure test fire hydrant, the pressure is not less than 0.7kg, water column can reach 7 meters. 3, the old engineering fire hydrant system test, pay attention to the pump flow and lift, generally more than two water nozzles, otherwise it may cause excessive pipe pressure. 4, test hydrant button should pay attention to whether the f