液压知识（Hydraulic knowledge）.docVIP

液压知识（Hydraulic knowledge） The main characteristics of low speed hydraulic motor is large displacement and large volume low speed (sometimes up to a few tenths of a per minute to even turn), it can be directly connected with the working mechanism, does not need the deceleration device, the transmission mechanism is simplified, usually low speed hydraulic motor output torque is large, it is also known as low speed high torque hydraulic motor. Method for finding hydraulic failure According to the hydraulic fault of hydraulic system in the map to find the hydraulic system diagram analysis and troubleshooting, the main method is to grasp -- a power source (pump) and grasping actuator (cylinder and motor), and even the middle, from the source to after a pipeline and actuator between. When grasping two ends, it is necessary to analyze whether the fault lies in the oil pump, the cylinder and the motor itself. Even the middle in addition to pay attention to whether the fault analysis of connected line hydraulic components, but also pay special attention to clear transfer system from one state to another state of the work is the use of what kind of control mode, whether the error control signal according to the kind, check one by one, it is necessary to pay attention to between the main circuit and the main circuit and control circuit have no wrong and mutual interference phenomenon, such as mutual interference phenomenon, how to regulate the use of error analysis The hydraulic motor can be divided into gear type, vane type, plunger type and other types according to its knot type. According to the rated speed of hydraulic motor, it is divided into two categories: high speed and low speed. Rated speed is higher than 500r/min belongs to high-speed hydraulic motor, rated speed of less than 500r/min belongs to low-speed hydraulic motor. The basic types of high speed hydraulic motors are gear type, screw type, vane type and axial plunger type, etc.. Their main features are high sp