房屋装修水电安装工程验收不可忽视的17个细节（There are 17 details of the acceptance of the installation of the installation and installation of the house）.docVIP

房屋装修水电安装工程验收不可忽视的17个细节（There are 17 details of the acceptance of the installation of the installation and installation of the house） There are 17 details of the acceptance of the installation of the installation and installation of the house When decorating, when facing the acceptance of hydropower project, most of the owners are often unable to do the work, do not know how to check the workers construction to conform to the norms. If you have such a situation, you may as well follow up with the small group to see what details are concerned when the supervisor inspects the hydropower project. 1. Follow the horizontal vertical principle The first thing to do is to see whether the water pipes and wires are properly laid. If the water pipes are not properly buried, then when the water and electricity is completed, it will be difficult to confirm the location of the embedded water pipes. In the later stage of construction, it is necessary to nail the wall surface, and it is possible to wear water pipes or electric wires carelessly, causing water pipe burst, electric wire leakage, etc. And if it needs to be serviced later, it will be difficult to find the location of the water line. Key details: water and electricity laid should follow the principle of horizontal flat vertical, another of the same indoor switch socket should also at the same level, switch off the ground 1.4 meters, the height of the socket and the ground should be keep in 30 cm. 2. The launching pipe shall be protected Some construction personnel work is careless, for hydropower construction transformation, not the protection on existing water pipe, which didnt put the toilet drainage pipe and sink drain pipe mouth closed. This can cause the construction to fall into the water pipe and cause blockage. Key details: in accordance with the construction specification, before the construction of hydropower transformation, the finished products should be protected, and the closure of the launching pipe is one