条形码扫描技术（Barcode scanning technology）.docVIP

条形码扫描技术（Barcode scanning technology） Bar code reader is an electronic device, read the barcode printing. As a platform for scanner, it includes a light source, a lens and a light sensor turns light into electrical impulses. In addition, almost all of the bar code reader contains decoder circuit analysis barcode image data provided by the sensor and send the content of the barcode scanner output port. The scan of the bar code requires the scanner, which USES its own light source to illuminate the bar code, and USES the photoelectric converter to accept the reflected light to convert the light from the reflected light into a digital signal. No matter what rules are printed, the bar code is composed of static, starting, data, and terminating characters. Some barcodes also have check characters between the data character and the termination character. Bring about static area: the quiet zone is also called the blank area, divided into left and right blank area blank, left blank area is prepared to scan to scan equipment, right blank area is to ensure that correct identification of the end of the bar code scanner. In order to prevent the blank area around (dead zone) in typography is occupied by a unintentionally, can be a symbol of blank area printing (no Numbers printed on the left side of the number, there is no digital printing on the right side ) this symbol was called dead zone. The main function is to prevent the lack of width. As long as the static area width can guarantee, whether this symbol does not affect the identification of barcode. Start character: first character, with a special structure, when the scanner reads the character, it begins to read the code formally. The main content of the data character: barcode. Calibration character: verify that the data read is correct. Different coding rules may have different validation rules. The termination character: the last character, which has a special structure, is used to tell the code to be scanned, and it a