总线区别（Bus is the difference between）.docVIP

总线区别（Bus is the difference between） The difference between: SPI: high-speed synchronous serial port. 3 ~ 4 interface, send and receive independent, can be synchronous UART: universal asynchronous serial port. The standard baud rate completes two-way communication, slow I2C: a serial transmission mode, three-wire system, which can find its communication protocol and usage Three lines realize two-way transmission of data Serial peripheral interface Serial interface UART: universal asynchronous transceiver UART is a chip used to control computer and serial devices. One thing to note is that it provides the rs-232c data terminal device interface, so that the computer can communicate with the modem or other serial device that USES the rs-232c interface. As part of the interface, UART also provides the following functions: The parallel data transferred from the inside of the computer is converted into a serial data stream of output. The serial data from the outside of the computer is converted into bytes for the use of devices that use parallel data inside the computer. In the output serial data stream, the parity bit is added, and the parity of the data flow received from the outside is used. Add the stop tag in the output data stream and remove the start-stop tag from the receive data stream. Handle the interrupt signal from the keyboard or mouse (the keyboard and mouse tickets are also serial devices). The synchronization management of computer and external serial devices can be handled. Have some of the more upscale UART also provide input and output data buffer, relatively new UART is 16550 now, it can be in front of the computer to deal with the data in the buffer storage within 16 bytes of data, and usually the UART is 8250. Now, if you buy a built-in modem, there is usually 16550 UART inside the modem. I2C: a parallel bus that can be used as an alternative to a standard and can be connected to various integrated circuits and functional modules. I2C is a multi-mast