蜂窝夹层板在patran中建立.pptVIP

* * * * * * * * * * * * * * * * * * * * * * Mar120, Workshop 10, March 2001 WS7B-* PAT325, Workshop 7B, April 2007 Copyright? 2004 MSC.Software Corporation Mar120, Workshop 10, March 2001 WS7B-* PAT325, Modeling Honeycomb, July 2003 WORKSHOP 7B MODELING HONEYCOMB WITH SOLID AND SHELL ELEMENTS WS7B-* PAT325, Workshop 7B, April 2007 Copyright? 2004 MSC.Software Corporation Problem Description Unlike the previous workshop that involved modeling the honeycomb structure using the MSC.Laminate Modeler, this workshop is used to show how to model the honeycomb structure using solid and shell elements. Solid hexahedral elements are to be used to represent the core, and shell elements are to used to represent the laminate backing. Similar constraints and loading are to be applied to the model. After the MSC.Nastran analysis the results are to be looked at, and perhaps compared to those for the previous laminate model. Suggested Exercise Steps Create a new database Import two surfaces from an IGES File Create a solid from the two imported surfaces Mesh the solid using IsoMesh Mesh at surfaces of the solid using IsoMesh Equivalence the solid and surface meshes Cantilever one end of honeycomb model Apply the force load at the free end of the model Create material properties using a session file Create the isotropic material for the core Create a composite material using laminate in MSC.Patran Create 3D element property set for core material Create element property for upper lamina Create element property for lower lamina Analyze the model and attach the results file Verify the stress tensor and displacement results d e f b c Step 1. Create a New Database Create a new database. File / New. Enter 2nd _Honeycomb as the file name. Click OK. Select MSC.Nastran as the Analysis Code. Select Structural as the Analysis Type. Click OK. a Step 2. Import two Surfaces From an IGES File Import two surfaces from an IGES file. File / Import Select IGES from the Source. Select exercis