飞剪操作（Flying shear operation）.doc

飞剪操作（Flying shear operation） 2. Flying shear The bad consequences of the billet tongue and fish tail: 1) the temperature of the tongue shape and the fishtail section is lower than that of the strip, and the rolling system of the finishing mill often causes the roller to produce the indentation, causing the surface of the strip to produce roller defects, affecting the quality of strip steel. 2) tongue and tail rolled piece, rolling in the finishing mill group, easy generation, the rolled piece wandering in a spin, transporting and winding process, the seam drilling equipment parts, card steel caused by accident, make the equipment damage or parking, influencing on working factor of rolling mill. 3) it has the steel of the tail, the binding is difficult, and the strapping is not tight. It is easy to cause the loose roll, which can cause the failure during the transportation and piling of the steel coil, which can endanger the safety of the person and equipment. In order to prevent the occurrence of the above phenomenon, the tongue shape and the tail of the strip should be removed before entering the finishing mill group. The shearing order of different types of shear is described in detail below. Head cut: flying shear accelerates from waiting position. The tail cutting edge is cut in front of the slab, then cut the cutting edge of the head. After the shear is completed, the speed of the fly shear and the speed of the strip are synchronized until the fly shear opens to allow the billet to pass through. The flying shear rate drops slowly and enters the waiting position. Tail shear: flying shear accelerates from waiting position. Tail shear is performed in the tail section. After the shear is completed, the speed of the fly shear and the speed of the strip are synchronized until the fly shear opens to allow the billet to pass through. Then the cutting speed drops slowly and goes to the waiting position. Fly shear control to ensure that the tail cutting is not longer tha