1 过滤风速问题 气布比（1. Filter wind speed problem gas cloth ratio）.doc

1 过滤风速问题 气布比（1. Filter wind speed problem gas cloth ratio） 1. Filter wind speed The selection of filter wind speed is of critical importance to ensure the dust removal efficiency, to determine the size of the dust collector and the total investment of the system. In recent years, in the design of dust removal system in engineering project, the reason for the selection of filter wind speed is more and more low. (1) some designers believe that it is possible to improve the efficiency of dust removal, improve the efficiency of dust removal, enhance the ability to remove dust, and extend the grey cycle to extend the life of the filter bag. (2) in the past, some literatures or monograph specially emphasized that the filter wind speed could not be obtained too high, so as to avoid increasing resistance and higher running costs. (3) the current domestic bag dust removal (except for small bag dust removal unit) product samples of filtration velocity, mostly under 2.5 m/min, is common in the range of 1.0 ~ 1.5 m/min, for big bag is under 1.0 m/min, even with compressed air blowing ash removal of pulse bag filter, the filtering speed is highest at around 3.0 m/min, is a rare more than 4 m/min. Therefore, the designers tend to be easy to select the filter wind speed of the product samples, and then lower the value to determine the filter area, which leads to the low value of the filter wind speed. Based on the above reasons, the phenomenon of filtering wind speed in the design work of 0.1 ~ 0.25 m/min is abundant. It should be said that these reasons are not unreasonable. But if easily reduce filtration velocity, even if the absolute value of lower smaller, such as 0.1 ~ 0.25 m/min, which will increase the filter area about 10%, equipment investment will also increase nearly 10%, processing of air volume, the greater the increase in investment is, the more equipment area also increased accordingly. Obviously, this is not economical; It is also inappropriate to view the above r