结构布置（The structure arrangement）.docVIP

结构布置（The structure arrangement） The structure arrangement Classification: architectural design | label: architectural design Structural design specification Mainly is the design basis, the seismic grade and level of civil air defense, to love and the bearing capacity of gay, moistureproof, live load value, material level, the matters of attention in the construction, choose detail, detail drawing or nodes, and did not draw in the shop drawing and through instructions to convey information. For example, cement mortar shall be used as below zero, and mixed mortar shall be used. And so on. 2. Structure layout of each layer, including: (1) layout of precast board (selection of plates, size of plates and reinforcement). When marking the number and type of precast plate, do not use diagonal form. Because this method is easy to cross the line, use horizontal or vertical lines, the same type of room direct standard room type number. Should complete building unified number, can reduce design workload, also facilitate construction personnel to look at the picture. The seam is as high as 40, which can not be reinforced or reinforced. When cloth board, from inside the room to cloth board, use wide board as far as possible, the current casting belt is left in the window, the current cast bandwidth is better than 200 (consider the vertical tube of water warm). The seam should be more than 60 if the structure requires an entire cast. The whole layer is 50, with two - way phi 6 @ 250, concrete C20. The horizontal wall or transverse wall (horizontal wall) shall be used to combine the load-bearing scheme with good resistance to collapse. No precast board is allowed in the constructional column. It is suggested that the PMCAD should be used for the precast board of the worksheet, which may not meet the requirements of the users construction drawing and can only meet the requirements of defining load transmission line. It is very sensitive to the floor height, over 6.9 meters, or if it