焊接操作规范（Welding operation specification）.docVIP

焊接操作规范（Welding operation specification） Q/XZJ 13004-2006 (2008) Before the speech This standard is a revision of the welding procedure for XZ/YB 3106-93. The main changes compared with XZ/YB 3106-93 are as follows: - this standard is in accordance with national standard GB/T 1.1-2000, the first part of standardization process: standard structure and rules of writing To edit; -- the standard name welding procedure code is changed to welding operation specification; - added normative references; - modify the procedures for welding operation; - added the contents of post-weld treatment, weld repair and weld inspection; This standard was first published in 1993. This is the first revision. Q/XZJ 13004-2006 (2008) Welding operation specification 1 scope This standard specifies the procedures for the companys welding procedure. This standard is applicable to welding of welds of products manufactured by our company (including the cooperative factory). Normative reference documents The terms and conditions of the following documents shall be used as the terms of this standard by reference of this standard. A reference file that is filled with date, followed by all The amendment (excluding the contents of the errata) or the revised version shall not apply to this standard, however, the parties to the agreement shall be encouraged to study Can you use the latest version of these files? The latest version of a reference file that does not date will apply to this standard. GB/T 3375-1994 welding terminology GB 9448 welding and cutting safety Specification for welding process of Q/XZJ 13005 Weld quality and inspection of Q/XZJ 15004 Q/XZJ 13010 welding defect repair Q/XZJ 13018 process code 3 terms and definitions The terms and definitions established by GB/T 3375 apply to this standard. Preparation before welding 4.1 skilled in the welding process of the workpiece needed for welding operation, the drawing and process shall be fixed on the required drawing frame. 2. Prepare and