混凝土有关资料（Concrete information）.doc

混凝土有关资料（Concrete information） concrete Concrete is made of gelled material, water, aggregate degree and, when necessary, adding a certain amount of chemical admixtures and mineral mixture material, according to proper proportion coordination, after even mixing, compaction molding and curing hardening of artificial stone. Requirements for concrete specimen making 1. Production requirements of concrete test parts The specimen should be cleaned thoroughly before making the specimen, and then coated with the mould. Specimen with vibration table forming, concrete mixture should be a load test, loading application spatula along the test wall slightly when inserted dao and made concrete mixture test, top of the higher vibration should try to prevent mould on the vibration table free. The vibration should continue until the concrete surface is slurry, scraping away the excess concrete and smoothing it with a spatula. The vibration table shall be the technical requirements of the concrete laboratory vibration table (JG/T3020). When the test piece is artificially inserted, the concrete mixing material shall be loaded into the test mode on the second floor, and the thickness of the material shall be approximately equal. The steel rod used for ramming shall be: 600mm long, 16mm in diameter, and round in ends. The ramming is evenly distributed from the edge to the center in the spiral direction, and the tamping rod should reach the bottom of the test die when ramming the bottom. When ramming the upper layer, the tamping rod should be in the lower depth of 20 ~ 30 mm. When the ramming stick should be vertical, it should not be inclined, and insert several times with the spatula. The number of ramming of each layer should be determined according to the cross section of the test piece. Generally, it should not be less than 12 times per 100cm2 area. After ramming, remove the excess concrete and wipe with a spatula. Specimen, using standard curing should be tried in the temperature o