燃气灶使用事项（Use of gas stoves）.doc

燃气灶使用事项（Use of gas stoves） How is the embedded burner installed? 1. Installation process of gas burner From the kitchen burning gas boxes embedded hole template, according to the instructions on the use of the template and provide the size of the built-in holes on the surface of the hearth, pay attention to make the kitchen when opening distance with walls or other items unfilial and 15 cm, early sleep there shall be above 100 cm or more space. If installation of a lampblack machine, the installation of the lampblack machine will set up this space. 1. Preset gas burner insert hole To the oven pan lateral dust cap to remove the air tube joint, take special gas hose (9.5 mm diameter?), one end of the set of the red flag to tracheal joints, air supply valve at the other end, joint with pipe hoop banding. The hose should not be placed in the top of the cooker to reach the oven and from the bottom of the stove, not hard to bend. The liquefied petroleum gas range must use the qualified pressure reducing valve (rated pressure 2800Pa), the distance of the cooker is not less than 100cm, and the length of the hose is 100cm ~ 150cm. For example, pipe supply can be used for the use of special metal hoses and joints according to the local pipe network condition, and tighten the nut after the rubber pad on the joint. If using a special hose connection, the head shall be tightened with a pipe hoop. 2. Test of the gas burner Apply the soap to the trachea joint and open the valve of the air valve. If there is a bubble, the air leakage will be explained. Close the gas valve and adjust the hoops (or nuts) to try again until there is no leakage. 3. The gas range is loaded into the battery Counterclockwise to the end position, use your hand to press the inner shell of the battery box until you hear click and then release it. Load random parts 1 # batteries into the inner shell of the battery box to confirm positive and negative. Place the inner shell of the battery cartridge into the ba