湿度敏感元件保存和烘烤作业规范（Specification for preservation and baking of humidity sensitive elements）.doc

湿度敏感元件保存和烘烤作业规范（Specification for preservation and baking of humidity sensitive elements） 4 24 hours 48 hours 5 days 47 days 5 24 hours 48 hours 6 days 57 days 5a 24 hours 48 hours 8 days 79 days Less than or equal to 4.5mm 2a 24 hours 48 hours and 79 days 3 24 hours 48 hours 10 days 79 days 4 24 hours 48 hours 10 days 79 days 5 24 hours 48 hours 10 days 79 days 5a 24 hours 48 hours 10 days 79 days 7.1.3 sensitive components of SMT humidity sensitive components of a-5a are compared with table B: Table B: SMT humidity sensitive element unpacking service life table Humidity sensitive level disassemble service life 2 a 28 days 3, 168 hours 4 72 hours 5 to 48 hours 5 a 24 hours Note: the table set up in the workshop B conditions for temperature is less than 30 ℃; Humidity less than 60% RH, and sometimes may be beyond the requirements, so the humidity sensitive element in once opened its service life are on the lower level, such as level 3 of the original life of 168 hours, bring it down level by level 4 and decide the service life of 72 hours, and so on. 7.2 the warehouse 7.2.1 SMT seal humidity sensitive element warehouse storage conditions: temperature 18 to 25 ℃; Humidity 20-60% RH. 7.2.2 accept material need to confirm whether the material within the effective period 辶, sealed packaging, if you have bad feedback related department, if beyond the period of validity should be baked specific requirements with reference to the SMT humidity sensitive element baking general requirements table . 7.2.3 material distribution line should follow the principle of first in first out, tail, or their bulk packing priority (if 2-5 a grade a humidity sensitive element materials development, residual powder for vacuum seal or into the moistureproof ark save). 7.2.4 be careful when opening the seal, seal the seal at about 1cm in the seal, so that the bag can be used again. Meanwhile, the desiccant and humidity indicator card should also be kept well. 7.2.5 opened bulk material to p