弱电监控布线（Weak current monitoring wiring）.docVIP

弱电监控布线（Weak current monitoring wiring） One. TV monitoring system Good video transmission design is a very important part of CCTV monitoring system. If the construction of a set of good system chosen is able to produce or image processing high quality of the camera, camera, monitor, video recorders, but without good transmission system, finally on the monitors will not be able to see the image is satisfactory. According to the rules of the barrel, the final image quality will depend on the worst of the whole system. The worst part of this is the transmission system. The system design and installation personnel must according to the actual need to choose the right means of transmission, high quality transmission lines and equipment, and installation in accordance with professional standards, to achieve the ideal effect of transmission. Video signal transmission is generally used in the form of direct modulation technology and base band frequency (about 8MHz bandwidth). The most commonly used transmission medium is coaxial cable. Coaxial cable is specially designed to transmit video signals, and its frequency loss, image distortion and image attenuation are relatively small, which can perfectly perform the task of transmitting video signals. In general, the dedicated SYV75 ohm series coaxial cable is used, and the commonly used model is syv75-5 (it is usually 300-500m for the transmission distance of video signal); In the distance, the coaxial cable of syv75-7, syv75-9 or even syv75-12 shall be adopted. (in actual engineering, the unrepeatable transmission distance of the coarse cable can reach more than 1km); Also have by adding video amplifier in order to enhance brightness, chroma and synchronization of the video signal, but line interference signals can be amplified, too much so loop cant concatenated video amplifier, otherwise there will be a saturated now like, leads to the distortion of the image; Farther way of using optical fiber transmission, optical fiber tr