对电梯上行超速保护装置设置要求的建议（Suggestions for setting up the elevators uplink overspeed protection device）.docVIP

对电梯上行超速保护装置设置要求的建议（Suggestions for setting up the elevators uplink overspeed protection device） Suggestions for setting up the elevators uplink overspeed protection device Sun lixin, tianjin special equipment supervision and inspection technology research institute Related to the work, the author reviewed about the elevator uplink speeding protection standards at home and abroad, investigate to the elevator industry to perform relevant information, these standards have a little bit feeling or Suggestions, such as mentioned in the title of this paper. Imploring the elevator staff to support, revise or criticize the authors views. 1. The standard for the upward speed protection device In the past, the elevator only set up the cars downward speed protection device, and the European elevator standard, en81-1, changed the speed protection of the cage into the safety device that was necessary for the traction elevator when it was changed in 1998. China elevator standard GB7588 elevator manufacturing and installation safety codes using equivalent and EN81-1, after the European EN81 issued 1998-1, GB7588 version follow up from 1995 to 1995, has increased the upgoing overspeed protection clause. The main contents are: (a) drag driving lift should be equipped with a qualified cage upward speed protection device. (2) the device includes speed monitoring and deceleration element, speed monitoring should be the speed limit device or the device that meets the requirements; The deceleration element should be applied to the car, or to the weight, or the wire rope system, or the tractor wheel (for example, to apply directly to the drag wheel, or to the trailing wheel shaft closest to the drag wheel). (3) the upstream overspeed protection device is a safety component and shall be verified according to the requirements of F7. General administration of quality supervision, inspection and quarantine (in fact already in implementing) in formulate the traction regulations and mandatory dr