侉子的调试与维修(KuaZi debugging and maintenance).docVIP

侉子的调试与维修(KuaZi debugging and maintenance).doc

  1. 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
  4. 4、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
  5. 5、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们
  6. 6、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
  7. 7、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
侉子的调试与维修(KuaZi debugging and maintenance) The commissioning of the Yangtze river 750 and the troubleshooting of common troubleshooting and practical small technology 2012-2-4 09:54 reading (15) praise the comments reproduced (5) share the copy address to edit the previous article? | : our military uniform size... If there is an abnormal amount of oil consumption in the Yangtze river 750, the reasons are often related to the following two factors: first, left, and the right cylinder is not adjusted. To the best point, the second one is left, and the right cylinder turns the filling cable out of sync. The adjustment of this kind of problem is as follows: first, adjust the left and right cylinder idle speed and first clean the two carburetors. Loosen the idle nut and adjust the screw to the bottom (the screw doesnt reach the throttle valve) to keep the throttle down. Check the size of the two main fuel injection tips (if not the size of the same size to be grinds to the same), and the same card in a carring position. After all installed, can start the engine to adjust the idle speed, first set the two cylinder idle speed to the basic stability after the fine tuning. To fine-tune the left cylinder: first car in idle running, increase the right cylinder spark plug cap up slowly, when out of the spark plug to make right cylinder to stop working, if the left cylinder reciprocating slowly stopped after three or four times, that the cylinder deactivation appropriate; If you stop immediately, you will need to exit 1/2-1 of the idling screw out of the cylinder. Then the right cylinder is removed and the left cylinder is not stopped by itself. This is the best point. Then adjust the right cylinder in the same way. After the two cylinder is adjusted, lock the nut tightly, such as the idle running 3min time not stop can achieve the purpose - idle at the same speed. Keep in mind: dont set the idle speed too low, its bad for the engine, and its fuel wont burn fully. Especially in w

文档评论(0)

jgx3536 + 关注
实名认证
文档贡献者

该用户很懒,什么也没介绍

版权声明书
用户编号:6111134150000003

1亿VIP精品文档

相关文档