饰面砖施工及验收规范（Specification for construction and acceptance of facing brick）.docVIP

饰面砖施工及验收规范（Specification for construction and acceptance of facing brick） I. code for construction quality acceptance of building decoration works (GB50210-2001) Two. Building quality acceptance specification for ground engineering (GB50209-2002) Three. Inspection standard for bond strength of building facing brick (JGJ110-97) 8 decorative panel (brick) project 8.1 general provisions 8.1.1 this chapter is applicable to the quality acceptance of the panel installation and the partition of the facing brick. The following documents and records shall be checked when acceptance of the 8.1.2 decorative panel (brick) works: 1 decorative panel (brick) works drawings, design instructions and other design documents. 2 product qualification certificate, performance test report, incoming acceptance record and reinspection report. Field drawing test report of 3 embedded parts. Test report on bond strength of 4 exterior wall facing brick sample. 5 acceptance records of concealed works. 6 construction records. The 8.1.3 panel (brick) project shall be tested for the following materials and their performance indicators: 1 radioactivity of granite used for indoor use. 2 adhesion of cement with the setting time, stability and compressive strength. 3 water absorption rate of ceramic tile on exterior wall. 4 frost resistance of ceramic tile for exterior wall in cold area. The 8.1.4 decorative panel (brick) project shall be checked and accepted for the following concealed works: The 1 parts (or post embedded pieces). 2 connection node. 3 waterproof layer. The inspection batches of each sub project of the 8.1.5 shall be divided according to the following provisions: The indoor decorative panel 1 the same material, technology and construction conditions (brick) project every 50 (large rooms and corridors in the construction area of 30m2 for a) should be divided into a test group, less than 50 also should be divided into a test group. Room 2 exterior panels the same material, technology and