光纤通信阶段2（Fiber communication phase 2）.doc

光纤通信阶段2（Fiber communication phase 2） 1. Single item selection (total 20 questions, 100.0 points) The interface between transmission devices and other network elements, the interfaces between network nodes, is often referred to as. NNI UNI V 2 m interface Knowledge point: SDH concept Student answer: [A;] Score: [5] test score: 5.0 Tip: The commonly used SDH devices have a terminal multiplexer and a digital crossover connector. ADM EDFA WDM The PIN Knowledge point: SDH concept Student answer: [A;] Score: [5] test score: 5.0 Tip: The number of frames per second for stm-4 is __________. 4000 4000 x 4 8000 8000 x 4 Knowledge point: SDH calculation Student answer: [C] Score: [5] test score: 5.0 Tip: The number of bytes contained in a stm-16 frame is __________. 10 * 16 * 9 10 * 16 * 9 x 8 261 * 16 * 9 261 * 16 * 9 x 8 Knowledge point: SDH calculation Student answer: [C] Score: [5] test score: 5.0 Tip: (error) adding a byte of channel overhead per frame on a c-4 basis constitutes a VC - 4. 45 27 10 9 Knowledge point: SDH multiplexing mapping structure Student answer: [C] Score: [0] test score: 5.0 Tip: (error) is the composite decomposition point of the virtual container. RST VC PT The MST Knowledge point: SDH multiplexing mapping structure Student answer: [D;] Score: [0] test score: 5.0 Tip: (error)... is an information structure that provides adaptive capabilities in the higher-order channel layer and the multiplexed segment. AU VC Low resistance type High resistance type Knowledge point: SDH multiplexing mapping structure Student answer: [D;] Score: [0] test score: 5.0 Tip: (error) In the wavelength division multiplexing system, the __________ technique is often used. Direct modulation Two-way pump Reverse bias The modulation Knowledge point: WDM network Student answer: [A;] Score: [0] test score: 5.0 Tip: The maximum light power is present in a channel in the WDM system. In the OTU EDFA input The output end of the EDFA Output end of LD Knowledge point: WDM network Stud