信号类1（Signal class 1）.docVIP

信号类1（Signal class 1） 1. Fill in the blanks (fill in the correct answers in brackets) 1. The basic occlusion method of driving is adopted automatic block, automatic inter-station block and (semi-automatic blocking). 2. When using a semi-automatic blocking method, the train will enter the interval by signal from the station signal or line. 3. When all the stops of the station are interrupted, the single-lane traffic shall be in written contact method, and the double-line driving (time interval method). 4. When the train is closed to the construction block, the train of the train enters the blocking interval (dispatching command). 5. 4 shows a green light and a yellow light in the automatic block - allowing the train to set off from the station, indicating that there are (2) block free zones ahead. 6. The incoming, outbound, incoming signal and line are all displayed by signal (stop signal). 7. It shall be deemed to be (stop signal) when the station, the outbound, the entrance and the light of the signal are extinguished, the display is unclear or the display is not correct. 8. The work shall be located at the two ends of the construction line and adjacent line distance (500-1000) m. 9. The deceleration location is set at each end of the deceleration site (20) m. 10. After the rail car has been hung, the speed of operation must not exceed 20km/h, and it shall not be run across the range. 11. The railway car repair is divided into three types (minor repair, item repair, overhaul). 12. Signal devices are generally divided into signal and signal devices. 13. The distance of the display device under normal circumstances shall not be less than (1000) m. 14. Adjust the operation of the car to accurately grasp the speed. No more than (40) km/h will be allowed when the traction operation on the empty line. 15. Adjust the operation of the car to accurately grasp the speed. No more than (30) km/h will be allowed to advance the operation on the empty line. 16. Adjust the operatio