螺纹知识（Thread knowledge）.docVIP

螺纹知识（Thread knowledge） Knowledge of.Txt thread if the heart clean, one world, a bird and a heaven. I used to love you, now I still love you want to get to where the moon can leave you smile those snowy winter, the umbrella of youth, that is blocking the door to the oath, the string of snow covered [text]. 1. Standard screw thread All types of teeth, diameter and pitch are in line with the national standard of thread, known as standard thread. The following describes only plain threads, trapezoidal threads, and non hermetic seals Pipe thread. Since the thread adopts the prescribed drawing method, the thread elements and their accuracy are not fully expressed, so the thread is to be marked in the drawing Note. The complete marking of the thread is: thread characteristic code (tooth type), size code (big diameter, lead, pitch, line number), tolerance zone code (top diameter diameter), screwing length code (short, medium and long), rotating code (dextrorotation). The code of the standard thread is directly marked as the dimension text, and the size index of the pipe thread is qualitative, so the lead line is used to mark out the line Route extraction. 2. Nonstandard thread Standard thread, such as tooth shape, diameter, etc, is called nonstandard thread. Nonstandard threads do not have a special code number, and each dimension is required to be marked Technical requirements, etc. Standard thread shall be used as far as possible. For single thread, plain thread The format is marked (GB/T197-2003, 2004): [text] For coarse teeth, ordinary threads without marked pitch, such as M16, are expressed as coarse, plain, and thread pitch, which can be obtained by consulting standards. Fine thread must be marked The pitch, such as M16X1.25, is defined as fine ordinary thread with a pitch of 1.25. The tolerance code is marked according to the order of the middle diameter and the top diameter, indicating the tightness degree of the thread connection. It is represented by the numeral l