水泥性能试验（Cement performance test）.docVIP

水泥性能试验（Cement performance test） (1) cement experiment The cement quality and the physical mechanical properties of cement are tested by cement experiment, and the original data is provided for the matching design. At the same time, the cement quality is evaluated and the unqualified cement can not be used. 1. Experiment of cement fineness The fineness of cement directly affects the solidification time, strength, hydration heat and other technical properties of cement. Therefore, it is of great importance to determine whether the fineness of cement meets the standard requirements. The test method of cement fineness is: negative pressure screening, water sieve and dry sieve. The percentage of the quality of the sample was represented by the thickness of the cement with 0.08 mm square hole sieve, and the measured value was used as the experimental result. If there is any dispute, the negative pressure screen shall prevail. (1) main instruments: negative pressure sieve analyzer; Balance: maximum weighing 500g, sense of 0.01 g. (2) experimental procedures and experimental results Before screening the experiment, put the negative pressure sieve on the screen, cover the screen, connect the power, check the control system, and adjust the negative pressure to the range of 4000 ~ 6000Pa. (2) according to the test of 25 g, put in clean negative pressure screen, cover screen cover, on the screen on, start the sieve analysis instrument for 2 min, sieve analysis in the process of the sieve analysis are attached to the screen cover sample, if any, can gently knock agent, sieve sample sets. The sieve residue (accuracy to 0.01 g) was measured and the percentage of sieve residue was calculated. The results were accurate to 0.1%. 2. Experiment on water consumption of cement standard consistency The amount of water used for cement standard consistency is expressed as percentage of cement content. The thin consistency of cement slurry has a great influence on the time of coagulation and