电工复审（Electrical review）.doc

电工复审（Electrical review） 2, after closing to send electricity to the power switch device or on the line, the handle should be suspended (prohibit closing, people work signs). 3, when using a ladder, a ladder and the ground point should be (60-65) degrees is appropriate. 4, maintenance of electrical equipment in high temperature environment, (should be avoided in the charged case) operation. 5, low voltage power cable equipment grounding wire or multi wire and wire wrapped in the same protective casing grounding wire, the minimum copper core section (1 mm). 6, fire electrical equipment, fire fighting equipment is usually prohibited (foam). 7, the main reason of personal electric shock death is caused by the current body (physiological reaction) caused by. 8, according to the provisions of the national standard GB3805-83, maximum safe voltage range of values is refers to between two conductors or any conductor and shall not exceed the AC RMS (50 volts). 9, general residential, office space, if to prevent electric shock as the main purpose, should be used for leakage current (30 MA) leakage protector. 10, a movable electric tool and switch board (box) of the power line must be used (copper core rubber sheath soft cable or copper core PVC insulated sheathed flexible cord). 11, the installation height for charging electric meter arrangement two layer, the upper surface at the bottom of the box to the ground vertical distance should not exceed (2.1 meters). 12, the fuse in the lighting circuit is as (overload and short-circuit protection device). 13, the gas discharge lamp lighting circuit of three-phase four wire system, the zero line cross section should be according to the phase (100% section of the rated current selection). 14, dry place normal indoor lighting, the chandelier and the ground vertical distance (1.8 meters) not less than. 15, low overhead and signs, wire canopy and iron gate metal must not be less than the distance (0.2 meters). 16, open type low-voltage