电影魔方教程（Rubiks cube tutorial）.doc

电影魔方教程（Rubiks cube tutorial） Use the movie cube how to improve the quality of the output file: To improve the resolution of 1. According to the size of the original image, set the corresponding output video resolution, suggest that the output in MPEG-2 format. 2. high bit rate. You can set the output file - VIDEO bitrate (kbps) large. As the output format of MPEG-2 file, you can set the output bit rate is 9800. The 3. variable bit rate. Can set the output file for variable bit rate video rate . How to set the output file cube film parameters: (steps) 1. in the timeline editing project; 2. click the button output; 3. in the save as window, set the save type to custom; 4. then in the output window can set the output audio and video format, video rate and other parameters. (*^__^*) hee hee And I also do not understand, will see... MPEG Video Wizard movie cube entry 05 2011 15 July 09:10:53 source: Wushan County Primary School: small font [Longgupo] MPEG Video Wizard movie cube entry The first chapter of the software installation and uninstall First, the system requirements Windows 98 / 2000 / XP 300 MHz processor 32 MB memory 8MB card Direct Sound compatible sound card 10 MB hard disk space for installation CD-ROM Drive Two, the installation of software Automatic installation The film magic cube CD-ROM in the CD-ROM, after a few seconds, the system will automatically start the installation program, according to the prompt order click Install, next, complete, to complete the installation. Manual install (if not the installation interface, please follow the steps below) Double click on the my computer icon and then double-click the CD Icon to find the file Setup.exe, double-click to run according to the prompt order click Install, next and finish to complete the installation. Three, software uninstall Select the start menu in the Windows operating system, select uninstall movie cube in cascading menu. The next operation according to the instructions. The second chapter u