空调故障 (2)（Air conditioner fault (2)）.docVIP

空调故障 (2)（Air conditioner fault (2)） Fault analysis of air conditioner. Fault analysis and refrigeration system Suction / discharge pressure 1. check compressor. Suction / exhaust pressure should be smaller than the range given in Table 1 for the normal operation of air conditioner refrigeration system is given in Table 1, if greater than the pressure value, is not normal. When the ambient temperature is higher than the highest values given in Table 1 when the system pressure will increase, it can not think of refrigeration system failure. But in the ultra high temperature environment, the air conditioner is in overload operation, but also easy to cause the protective circuit, the air conditioner automatic shutdown. Table 1 the exhaust (condensed) pressure and cooling medium temperature. The cooling medium high temperature, condensing pressure and condensing temperature also increased. Therefore, given in the table is the ultimate cooling medium under normal conditions the condensing pressure and temperature value. If beyond this range, the system is not running properly, should find out the reasons. 2. to observe the exhaust pipe of the compressor suction / condensation and temperature. The condensation tube of the compressor suction inlet pipe, pump shell and the pump shell body cold heat, the exhaust temperature is slightly higher, the refrigerant is moderate; no dew tube compressor suction, exhaust temperature is not too hot, indicating less refrigerant. But for the use of the expansion valve, should check whether the valve is open too small due to the compressor suction tube; condensation, as well as the pump shell is more than half of all condensation, too much refrigerant. If the use of the expansion valve, the valve can also be caused by too large. The rotary compressor, the normal pump shell is high temperature and high pressure gas, the pump shell and the exhaust pipe is always hot (or hot), not dew. 3. listen to the sound of the liquid flow throttling elem