梁的平法标注（Plane beam dimensioning）.docVIP

梁的平法标注（Plane beam dimensioning） Beam KL1 (2A) 200 x 500 said: 1 there are two cross beams, one end of the cantilever (A end, B said, both ends) section size 200 x 500. A plane representation of beams, columns, plates, and shear walls Plane representation of 1 beams 1.1 plane injection method On the floor plan of the beam, a beam is selected in different numbers of beams, and the size of the beam and the specific value of the reinforcement are written on it, as shown in figure 1-1. Fig. 1-1 example diagram of plane injection method Planar annotation includes centralized tagging and in situ tagging. The general value of the beam is expressed centrally, and the special value of the beam is expressed in situ. When one of the values in the concentration mark does not apply to a part of the beam, the value is used in situ, and when in use, in situ dimensioning is preferred. 1.2 section injection method On the floor plan of the beam, 1 beams are selected in different numbers of beams respectively, and the reinforcement diagram is drawn with the section number, and the sectional dimension and the concrete value of the reinforcement are written on it. The graph 1-1KL2 is represented by section injection (see Figure 1-2). Fig. 1-2 example drawing of section injection method 1.3 focus on content interpretation (1) number of beams; In practical engineering, a wide variety of beams may be encountered, and the flat method atlas classifies the beams as follows, see table 1-1. Table 1-1 classification and numbering of beams Beam type, code number, span, and whether or not cantilevered Storey frame beams, KL, XX (XX), (XXA) or (XXB) Roof frame beams, WKL, XX (XX), (XXA) or (XXB) Frame supported beams, KZL, XX (XX), (XXA) or (XXB); Non frame beams, L, XX (XX), (XXA) or (XXB) Cantilever beam XL XX Tic tac toe, JZL, XX (XX), (XXA) or (XXB) Note: (XXA) for one end of the suspension (XXB) for both ends of suspension, suspension is not included in the cross number. Example: KL2 (2A) stand