安装计算（Installation calculation）.doc

安装计算（Installation calculation） To get the drawings, first check whether the drawings are complete, complete, in the next step, Symbol recognition: all unlabeled figures except the elevation are m, and the rest are mm. (Schedule 1) all horizontal pipes that come in from the outside are called dry pipes. The ones that stand up from the dry pipes are called risers, and the ones that come out of the risers are called laterals. Make sure that the scale on the map is correct (1) Electrical Engineering (including high voltage parts, weak current parts and lightning protection earthing parts); First, strong electricity part: 1, familiar with the drawings: look at the design specifications, the design specifications on the engineering materials and parts of the lightning all down, then it is generally a legend, the legend of all need a number (the distribution box with different specifications, lamps, sockets, switches etc.) are respectively. The statistics of the number; see diagram to deal with the system plan, to understand the. System diagram on the general direction in the plane or circle (that only vertical go); about the direction of the system in plan; system diagram on the diagonal 45 degrees direction, in the pipeline plan to go around; push the vertical height map system tube with the elevation of the plane map can measure trunk and branch length of horizontal section; 2, engineering calculation process: first of all, from the outdoor to the main distribution box, the distribution box, the indoor distribution box and the circuit (lighting, socket, etc.). 3, the calculation procedure: first calculate the pipe (slot), then calculate the line (cable), the pipe (slot) does not enter the box, line (cable) into the box. 4, the relevant provisions: outdoor line drawings on unlabeled instances, outdoor reserved 1.5m (outdoor to exterior skin); cable into the box length 2m, length of wire into the semi perimeter box distribution box; not to practice, considering the practi