常州兄弟不锈钢电解抛光有限公司1（Changzhou brothers stainless steel electrolytic polishing Co., Ltd. 1）.docVIP

常州兄弟不锈钢电解抛光有限公司1（Changzhou brothers stainless steel electrolytic polishing Co., Ltd. 1） Daily maintenance of electrolytic polishing line stainless steel electrolytic polishing Daily maintenance of electrolytic polishing liquid 1. electro polishing, surface polishing will discover why like spots or small? Cause analysis: before polishing oil removal, the surface is still a stain. Solution: the bond brand oil wax removal liquid, 1:10 water, 60 - 90 DEG C under the condition of immersion for 5 to 20 minutes. As a long time after use should consider replacing the new liquid. 2. after polishing why local surface patches are black? Cause analysis: can not thoroughly clean the oxide skin. There are still local scale. Solution: increase the removal of skin strength, can choose the bond brand stainless steel descaling liquid, stainless steel descaling paste and other products. For derusting descaling more products, products can be applied Zhengbang Technology Co. Ltd. consulting. 3. after polishing workpiece edges and tip corrosion caused by what are the reasons? Cause analysis: parts of the edges, the tip of the current is too large, or the electrolyte temperature is too high, the polishing time is too long, resulting in excessive dissolution. Solution: adjust the current density or temperature, or shorten the time. Check the electrode position in the corners of shielding etc.. 4. why the workpiece polishing after light and dark gray? Analysis of reasons: the possible electrochemical polishing solution has no effect, or the effect is not obvious. Solution: check whether the electrolytic polishing liquid used for a long time, the decline in the quality, or the solution composition proportion. 5. polishing surface with white stripes is going on? Cause analysis: solution relative density is too high, the liquid is too thick, the relative density is greater than 1.82. Solution: the degree of agitation of the solution increases, if the solution density is too large, dilute with