发电机（Alternator）.docVIP

发电机（Alternator） 1 Introduction Xishui power plant 4 * 135MW generator, Shanghai Turbine Generator Co. production QFS50 300MW series dual internal water cooled turbo generator, model QFS - 135 - 2, respectively in September 2001, January 2002, July 2002, October 2002 grid. No. 4 machine had Water Leakage generator fault shutdown event after stop check Water Leakage reasons for stator cooling water pipes due to blockage of the superheater tube to. After the unit maintenance, found the other 3 units of the stator clamping ring cooling pipe blocking phenomenon also exist in different degrees, timely dredge treatment, to avoid similar accident. No. 24 generator Water Leakage fault phenomenon and check processing In July 21, 2008 14:30, an alarm generator No. 4 leak detector, on-site inspection found the generator body with water spray, reduce the cold water pressure generator in the regulation is invalid, check the downtime for fault (before the stoppage of the unit load 80MW, power factor 0.95, generator coil temperature, core temperature and air cooling, water cooling system parameters of normal). After exposing the development of motor end cover check, Water Leakage reasons for the exciter end of generator stator cooling water pipe to pipe explosion. Check the situation as follows: The cooling water pipe leak in the inner loop of the stator inner pressure ring, from 50 to 600 at the top of the generator. The cooling water pipe is at a slight bulge, the paint off phenomenon near the drain. The cooling water through the compressed air from the inlet side access check, compressed air, compressed air leakage and leakage of compressed air from the outlet end access, no leakage of compressed air leakage. Reflect the cooling water outlet to the point (lower half circle) block. The opening check out of the water in the corner end leakage of cooling water pipe, water inlet pipe without debris, the inner wall of pipe is natural, the outlet pipe with black soft sediment. Check t