《机械制图》试卷3（Mechanical drawing test paper 3）.docVIP

《机械制图》试卷3（Mechanical drawing test paper 3） Documents from the network, I collected, finishing, and if there are omissions, errors, but also please correct me! Second semester of the 2008-2009 academic year Physics and mechanical and electrical engineering 08 level mechanical major Mechanical drawing final examination paper (A) Question no. Fraction One Two Three Four Five Six Seven The total score The marking Reviewer Letter of commitment for examinee examination In I fill out the candidates information, that I have read and understood the relevant provisions of the Longyan University examination discipline and disciplinary measures, commitment in the exam self disciplined, any violation will be accepted; I promise in the examination of the subject, the personal information provided by me is true and correct Examinee signature: A single choice every day (1 points, 15 points Alternative answers every day in only one of the most to do) 1, the drawings on the fracture method, with () drawing A, thick lines. B, thin solid line C, double dotted line 2. The diameter of a sphere is 60mm, and the dimension shall be () A, ball R30 B, S Phi 60 C, S60 3, a straight line perpendicular to the frontal projection plane (V plane), then its projection in the horizontal projection of the () A is still straight, and the length is constant B, accumulate as a point C is still straight and shorter in length 4, adjacent to two metal material objects, its profile line general () A and skew must be different B, diagonally opposite C equal in angle, equal in interval 5, the ladder section view belongs to () A and partial cutaway view B and full cutaway view C and half cutaway view 6. When marking the following form and position tolerances, it is not possible to mark the reference symbol A and parallelism B and symmetry C, flatness 7. The drawings of the overlapped sections are drawn in the view, and the contours are drawn () A, outside, fine solid line B, besides, thick lines. C, inside, fin