ad6画板（AD6 drawing board）.docVIP

ad6画板（AD6 drawing board） First of all, build a project - add schematics and PCB diagrams to the project (save). The principle diagram and PCB diagram of the original device, device package, respectively, to generate the original library and package library. Step: open the schematic diagram, PCB diagram - design generation principle library / generate PCB Library (save), you can generate the principle library / generate PCB library file in the schematic diagram and PCB diagram folder If the supplied library file does not contain the required components or components, it must: Step: establish a component or component library - complete component rendering (save) - add the library to the project - you can put the device in the schematic diagram and the PCB diagram Note: painting components or components of the package must be painted at the origin (origin, that is, the reference point), or else from the schematic diagram to PCB, you will find the device package (remember to add packages to devices that are not encapsulated, and each file must be saved.) You can add new library files (component library, wrapper library, original package library) in schematic interface and PCB diagram interface In principle, if the original package is not available, you can add a package library (package library inside the package will automatically loaded into the schematic inside the device package name of the same device) Steps: turn on schematics, PCB diagrams - Design - add / remove Libraries - install - select file types, files You can put the components in the library at the schematic interface, and put the package inside the library in the PCB diagram interface Mode 1: select the put device shortcut icon directly in the schematic or PCB diagram interface. Mode 2: place the device in the schematic or PCB diagram interface The steps to import a schematic into a PCB diagram are as follows: The steps of establishing the principle diagram and PCB - to ensure that every component packa