uv上光常见故障（UV glazing common faults）.docVIP

uv上光常见故障（UV glazing common faults） UV glazing common faults,.Txt lift up, put down, called weight lifting, lifting can not put down, called weight. The head should have courage, and rise to have the spirit. Learn to add, pride to subtract, opportunity to ride, sloth to divide. The three problems of life: thinking, love, Unrequited love. UV glazing common faults and troubleshooting methods (Part I) 2006-9-21 10:47:11 of the Chinese printing and packaging web feeds There are many factors on the actual UV, due to the carrier substrate, ink of different types, different polishing methods and equipment, characteristics and requirements of different printing products, affect the UV light oil formula composition are different, so the light fault and imagination are not the same, this paper will present the most widely used a paper printed on the main analysis, for reference. One, brightness is bad, glossiness is bad 1, fault phenomenon Light oil viscosity is too small, coating is too thin. The paper is rough, smooth and absorbent. The anilox roll is fine and the coating roller is less oil. Ethanol and other non reactive solvents over dilution. The printing surface ink is not dry. The ink repels oil, causing flooding and unevenness. The quality of the UV light oil, light is not good. The low temperature and high humidity. To light, light oil curing incomplete. The UV light oil mixed with impurities, not clean. 2, removal methods (1) to increase the viscosity of UV varnish and increase the coating quantity, without affecting the smooth and smooth surface of the coating, and like to be coated with some thickness as much as possible. If the paper is too coarse, it should be coated with a water-based base adhesive or solvent base adhesive. UV before printing, the ink should be fully dried. As a result of the reasons causing light ink, oil rejection, FA or influence of light oil and printing ink to have adhesion, bottom glue coating. UV light oil must be fully cured. If the ligh