对接龙门举升机英文说明书.pdf

Important notes about your Lift… • Do not install this lift on any asphalt surface. • Do not install this unit on any surface other than concrete conforming to minimum specifications. • Do not install this lift over expansion joints or cracks. Check with building architect. • Do not install this lift on a second floor with a basement beneath without written authorization from building architect. • This lift is only as good as the floor you put it on. A good level floor is recommended for proper lift operation and installation. Cement should be minimum of 4” thick and 3,000 psi tensile strength with steel or fiber mesh reinforcement. • The lift is intended to raise the entire body of the vehicle only. Do not attempt to lift only part of the vehicle. Improper use of this equipment could result in damage to the lift, yourself or other property. • The lift is intended to lift vehicles only. It is not designed to lift any person or equipment containing persons. • All persons using this equipment should be qualified, responsible persons and should follow the operation and safety guidelines set forth in this manual. Improper installation can cause damage or injury. Manufacturer will assume no liability for loss or damage of any kind, expressed or implied, resulting from improper installation or use of this product. Read the installation and operation manual in its entirety before attempting to in ANCHORING TIP SHEET Anchors must be at least 6”from the edge of the slab or any seam. 1. Use a concrete hammer and a drill, a solid drill bit with a carbide tip, the same diameter as the anchor, 3/4”. Do not use excessively worn bits or bits that have been incorrectly sharpened. 2. Keep the drill perpendicular. 3. Let the