700 Series Disk and Drum Lathe Operators Manual（700系列盘式和鼓车床操作手册）.pdf

700 Series Disk and Drum Lathe Operators Manual FORM 4897-4 CHECK LIST 1. Standard equipment is shown on page 3. 2. Optional accessories are available from your John Bean Dealer. You may also order by contacting John Bean Company, Exchange Ave., Conway, AR.72032 or by calling 1 - (800) 362-8326 3. Assemble deluxe bench if ordered. The lathe can be mounted on either when removed from the carton. SAFETY INSTRUCTIONS Lathes sold and installed in the U.S.A. 4. DON’T USE IN DANGEROUS EN- Warning! should use only 3-wire extension cords VIRONMENT. Use lathe indoors only. For Your Own Safety, Read Instruc- that have 3-prong grounding plugs Don’t use lathe in damp or wet loca- tion Manual Before Operating Lathe and 3-pole receptacles that accept tions, or expose to rain. Keep work the power plug. area well lighted. 1. Lathes are supplied with a three- Repair or replace damaged or worn wire cord to provide grounding if your cords immediately. 5. DON’T FORCE LATHE. It will do electrical system is properly installed This tool is intended for use on a the job better and safer at the rate for by a qualified electrician and in com- circuit that has an outlet that looks like which it was designed. pliance with the national, regional and local electrical codes. 6. USE RIGHT TOOL. Don’t force lathe or attachment for a job for which 2. Improper grounding can cause it was not designed. electrical shock. In the event of a malfunction or