ADABDABDBFDAKAT ASABSBBSAFSA （ADABDABDBFDAKAT ASABSBBSAFSA ）.pdf

General Instructions (Centrifugal Fan) ADA-BDA-BDB-FDA-KAT ASA-BSB-BSA-FSA IGB016.E1/0902 This manual is to guide the users in the proper storage, installation, operation and maintenance procedures to ensure maximum equipment life and trouble-free operation. HANDLING AND MAINTENANCE SHOULD ALWAYS BE PERFORMED BY EXPERIENCED AND TRAINED PERSONNEL. RECEIVING, HANDLING AND STORAGE Rough handling during shipment and improper storage can cause damage that is not noticeable until the fan is in operation. This can be avoided with proper storage and handling techniques. Fan should be hoisted with slings placed around the fan housing. Touch up the scratch coated surfaces during lifting, to prevent corrosion to occur at this area. Store the fan in a clean and dry place, preferably indoor to ensure fan shaft, bearing and fan casing are protected against dust and corrosion. Do not store the fan in a location where it will be subjected to vibration. This can cause the internal surface to rub against each other and damage the bearings. START-UP CHECK LIST Before putting any fan into initial operation the manufacturer’s instruction must be followed. Complete the following checklist to make sure that the fan is ready to run.  Lock out the primary and all secondary power sources.  Make sure the foundation or mounting arrangement and the duct connections are adequately designed in accordance with recognized acceptable engineering practices and with the fan manufacturer’s recommendations.  Check and tighten all hold-down (securing) bolts.  Check the fan assembly and bearings for proper grounding to prevent static electricity discharge.  Spin impeller to see whether it rotates freely and is