Connecting a Bluetooth Scanner to your Android （连接蓝牙扫描你的Android）.pdf

Connecting a Bluetooth Scanner to your Android Device Chapter 1: CT 20/30 1 Chapter 2: Motorola Symbol CS3070 2 Chapter 3: Socket Mobile 7Ci 3 Chapter 4: Opticon 2002/2005 5 Chapter 5: Scanfob 2002/2005 5 Chapter 6: Navigating to Bluetooth Settings 6 Chapter 1: CT 20/30 Step 1: Scan the two barcodes below to factory reset your scanner. Step 2: Scan the three barcodes below to place the scanner in Android connection mode. Step 3: Press and hold down the scanner’s power button to turn off, and then press and hold the power button down again to turn the scanner on. Step 4: From the Android device, navigate to Bluetooth settings (Page 7). Find the CT20/30 in the device list, and then tap the scanner to connect. Step 5: When you are asked for a PIN code, enter the pin code ‘10010’ before pressing OK. Copyright © 2005-2014 Asellertool, Inc. All rights reserved. 1 At this time, the scanner should be properly connected to the Android device itself. Step 6: To disable the scanner sound, scan the three barcodes below. The CT20/30 user manuals can be found at /sh/yxatiyr2amqty9e/AADEhhJ29AJfhqwOR8niUJeGa?dl=0. Chapter 2: Motorola Symbol CS3070 Step 1: Turn on the scanner by pressing down on the ‘M’ button on the bottom of the scanner, until you see a green light appear at the top. The ‘M’ button’s blue light will flash slowly. Step 2: Scan the barcode below to place the scanner in pairing mode. Step 3: From the Android device, navigate to Bluetooth settings (Page 7). Find the CS3070 in the device list, and then tap the scanner to connect. Step 4: It will ask you to enter a code. Scan the number barcodes below. After you scan the number code, scan the ‘Enter’ barcode to finish. Copyright © 2005-2014 Asellertool, Inc. All rights reserved. 2 The CS3070 user manual and quickstart guide can be found here: /sh/e07lr9dwdfx3o5h/AACvsNXSq7Z_Xal54PzNlV