Controlled ON Time, Zero Current Switched（时间控制,零电流切换）.pdf

Controlled ON- Time, Zero Current Switched Power Factor Correction Technique Bill Andreycak Abstract: sion specifically targets the high harmonic content A general overview of various Power Factor of switching power supply capacitor input filters. Correction techniques and typical application issues This proposed spec defines limits for each harmonic is first presented. Emphasis is then focused on a component of the mains current, thereby requiring controlled on-time, non-resonant zero current power factor correction circuitry. IEC 555-2 har- switched (ZCS) technique. The control algorithm, monic current limits are proportional to power input design equations, required circuitry and general below 300W, but current limits are absolute above performance will be detailed. Experimental test 300W. This imposes especially severe requirements results of power factor and total har1fWnic distortion on high power supplies. using this approach and a Zero Voltage Switched When legislation such as IEC555 does not apply, (ZVS) derivative will be de1fWnstrated and com- it is tempting to rationalize that harmonic currents pared to the 1fWre conventional fixed frequency, will get lost among the other (resistive?) loads connected to the same branch circuit. But in an continuous current boost PFC technique.