Development of design criteria for RC interior B （开发设计标准为钢筋混凝土内部B）.pdf

This paper was published in ACI SP-123 Design of Beam-Column Joints for Seismic Resistance, James O. Jirsa Editor, American Concrete Institute, Michigan, 1991, pp. 97 - 123. DEVELOPMENT OF DESIGN CRITERIA FOR RC INTERIOR BEAM-COLUMN JOINTS Kazuhiro KITAYAMA, Shunsuke OTANI and Hiroyuki AOYAMA Synopsis: A series of research efforts, at the University of Tokyo, leading to the development of earthquake resistant design criteria for reinforced concrete interior beam-column joints are briefly summarized. The design criteria emphasize the protection of the joint to an acceptable deformation level of a frame structure during an intense earthquake. For the design against shear, shear resisting mechanism by truss and concrete compression strut, the role of joint lateral reinforcement, and the effect of transverse beams and slabs were studied experimentally. The requirement for beam bar bond was discussed on the basis of nonlinear earthquake response analysis. Keywords: Beams (supports); bond (concrete to reinforcement t); columns (supports); deformation; earthquake resistant structures; joints (junctions); reinforced concrete; shear properties; structural design Dr. K. Kitayama, graduate of University of Tokyo, is a research associate of Architecture at Utsunomiya University, Tochigi. He studies the behavior and earthquake resistant design of reinforced concrete beam-column joints. Dr. S. Otani, graduate of University of Tokyo and University of Illinois at Urbana-Champaign, is an associate professor of Architecture at the University of Tokyo. He was awarded with the 1990 Architectural Institute of Japan Research Award fo