Installation of Duo Cone Seals - Sintech（安装两锥海豹Sintech）.pdfVIP

Installation of Duo Cone Seals Seal Assembly and Installation Guidelines for Duo-Cone Seals Duo-Cone Seal Assembly Contents: - (2) Metal Seal Rings - (2) Elastomeric Toric Rings Terminology 1. Seal Ring 2. Rubber Toric 3. Housing Retainer Lip 4. Housing Ramp 5. Seal Ring Housing 6. Seal Ring Face 7. Seal Ring Ramp 8. Seal Ring Retaining Lip 9. Installation Tool Housing Preparation The housing components that contact the rubber toric rings (3 and 4) must be free from foreign material (oil, grease, dirt, metal chips, dust or lint particles, etc) before installing the seal. This should be done using a lint-free wipe and a non-petroleum based solvent. Dry with a clean wipe. Remove any foreign material from the rubber torics (2), the ramps (7) and the lips (8) of both seal rings. This should also be done with a lint-free wipe and a non-petroleum based solvent. Dry with a clean wipe. Place the rubber torics on the metal seal ring at the bottom of the seal ring ramp and against the retaining lip. Make sure the rubber toric is straight on the seal ring and not twisted. Be careful not to nick or cut the torics during the assembly, as this can cause leaks. Put the installation tool onto the metal seal ring and rubber toric. Lightly dampen the lower half of the rubber toric with the appropriate assembly lubricant. Techniques to dampen the toric include wiping with a lint-free towe