Induction Motors – Part I (V3) - College of （感应电动机我(V3)大学的一部分）.pdf

EE/ CME 392 Laboratory 7-1 Induction Motors – Part I (V3) Safety 1. The voltages used in this experiment are lethal. Assemble or modify a circuit only with the breakers off. Do not apply power to a circuit until an instructor has checked the wiring. Do not touch any node or component of a live circuit. Be careful when moving near a circuit so that a wire is not accidentally snagged. 2. The machines used in this experiment are physically dangerous. Guards must be in place over any rotating components before applying power. Do not wear loose clothing or neckties, and keep long hair away from the machines 3. If an emergency occurs, the power for the entire laboratory can be disabled using the red button on the power distribution panel. 4. Before starting the induction motor, make sure that the autotransformer and the starter box are cranked to position 0. 5. In the experiment, currents in various parts of the circuit may be very large; therefore, use high current capacity leads. 6. Use ammeters and wattmeter ’s with proper current ratings. 7. Ground all machines and the starter box by connecting them to the panel ground Objective : To study a 3-phase induction motor, by using its experimentally developed equivalent circuit diagram and by obtaining its basic characteristics: torque/slip, current/slip and efficiency /slip characteristics. Equipment: Induction machines on table numbers (1 and 6) have to be connected as a Y on the stator side whereas the machines on table numbers (3 and 4) have to be connected as a ∆.. Introduction - Equivalent Circuit Diagram and Losses The induction motor working in the steady state ( and s ) can be r