Marshall Turret Board Layouts Blue Guitar（马歇尔炮塔板布局蓝色的吉他）.pdfVIP

Marshall Turret Board Layouts Ive had some requests for a diagram of the JTM45 turret board layout, so here it is, along with a couple of later ones. These layouts are closely based on the original Marshall boards. The early amps didnt have a bias adjustment pot, so Ive included one on these, otherwise they are the same as the factory layouts. Ive broken them down into JTM45, Plexi and metal-face circuits, but there are no hard and fast rules where old Marshalls are concerned and there are probably amps in existence that mix and match elements of all three circuits. Click the pictures below to get the full versions. Disclaimer: Im not an authority on vintage Marshalls - this page has been produced from information Ive found on the web and in books. Corrections and/or additions are welcome. I havent shown the rectifier diodes on the Plexi and metal-face layouts - some had the power supply on the end of the turret board, next to the bias circuit, while others had the diodes on a separate board or mounted on the chassis. NB:These layouts are for 50W amps. The 100W amps had different power suppplies and bias circuits. JTM45 This is the original JTM45, basically the same as a 5F6-A Fender Bassman. There are minor changes in the power supply, but the circuit is virtually identical. JTM45 Layout JTM45 Under Board Wiring Plexi This is what I consider a Plexi circuit. Its very similar to a JTM45, but with higher B+ voltage, more power supply filtering, 470K mixer resistors, a bypass cap on the bright channel, and less negative feedback. They also changed from valve to solid state rectification and from KT66 to EL34 output valves. Plexi Layout Plexi Under Board Wiring Me