Mechanical Face Seal System Duramax Marine （机械面密封系统Duramax海洋）.pdfVIP

SEALING SYSTEMS Mechanical Face Seal System a Commercial Grade a Engineered for Propeller Shafts and Rudder Assemblies a Face Seal Configuration Available In 3 Mounting Methods: BRZ SYSTEM (shown) - Steel Hull FRP SYSTEM - Fiberglass Hull WELD-ON SYSTEM - Aluminum Hull PRODUCT INFORMATION AND SELECTION GUIDE ® Duramax Marine is an ISO 9001:2008 Certified Company The Next Generation of Mechanical Face Seals. Through extensive research, Duramax‚ Marine identified numerous design inefficiencies in many of today’s mechanical seal designs. These design problems can result in increased downtime, lower productivity and even hefty water pollution fines. Duramax Marine shaft seal experts, based on their research, designed this revolutionary solution–The Duramax Mechanical Face Seal System. 2 Inefficiencies of Other Mechanical Seals A mechanical face seal is a great choice but many come with hidden design problems. The face seal is designed with two finely-machined surfaces or faces located perpendicular to the shaft and pressed together to form a seal. One face surface - the seal ring - is attached to and turns with the propeller shaft. The other face surface -the friction ring - is part of the seal body. It remains stationary and does not turn with the shaft. The seal ring and the friction ring are arranged so that they are always in contact with each other. The seal body is normally a compressed rubber bellows or spring-loaded bellows that forces the stationary friction ring against the rotating seal