Manufacturing Processes AMEM 201 Review （生产过程 AMEM 201 审查）.pdfVIP

Manufacturing Processes - AMEM 201 - Review Questions - 2nd Group of Review Questions 1. The maximum possible draft in a rolling operation depends on which of the following parameters (two correct answers): (a) coefficient of friction between roll and work, (b) roll diameter, (c) roll velocity, (d) stock thickness, (e) strain, and (f) strength coefficient of the work metal? 1. Answer. (a), and (b). 2. Which of the following rolling mill types are associated with relatively small diameter rolls in contact with the work (two correct answers): (a) cluster mill, (b) continuous rolling mill, (c) four-high mill, (d) reversing mill, and (e) three-high configuration? 2. Answer. (a), and (c). 3. Flash in impression die forging serves no useful purpose and is undesirable because it must be trimmed from the part after forming: (a) true or (b) false? 3. Answer. (b). Flash causes build-up of pressure inside the die, which forces the work metal to fill the die cavity. 4. In which of the following extrusion operation is friction a factor in determining the extrusion force (one best answer): (a) direct extrusion or (b) indirect extrusion? 4. Answer. (a). 5. Johnsons formula is associated with which one of the four bulk deformation processes: (a) bar and wire drawing, (b) extrusion, (c) forging, and (d) rolling? 5. Answer. (b). 6. Most sheet metalworking operations are performed as which of the following: (a) cold working, (b) hot working, or (c) warm working? 6. Answer. (a). 7. In a sheet metal cutting operation used to produce a flat part with a hole in the center, the part itself is called a blank, and the scrap piece that was cut out to make the hole is called a slug: (a) true